Common faults of the winding machine must be common problems. To ensure the stable operation of a winding machine, it is an important and indispensable process for regular inspection and accurate operation. The work conditions and the doubts of the existence began to carefully table, and the most important straight -line sliding rail cutting and damage. The working mechanism has not been pulled, scientific research, and ups and downs. The equipment that should be reported to see if this is attributed to the defect analysis. At the same time, it should be described and inspected safety protection and energy supply. The limited equipment should be completely perfect. Check the household appliance power distribution cabinet should turn off firmness, electrical grounding, and check the equipment. Passing wheels, Mao Zhanjia line, porcelain element device, etc., should be perfect, precise equipment, and the speed of the speed experiment to see the stable work, no abnormal noise, etc. Although the above homework is complicated, it can be clearly defined in an excellent equipment condition and deficiency. Averse crystal three -dimensional rolling iron, foil winding machine

After detecting non -constant situations, you can carry out normal winding equipment. The operation in the operation process is not optimistic according to application standards. Many operations that accidentally form a certain degree of damage. Operation, do not do things that are not related to your job. In this matter, the equipment is interrupted, power -off, and natural gas should be based on technical requirements. It is not possible to increase the number of coil turns and cable line diameter, angle speed. There are no standards, loads, excessive winding machines, winding disks, whether the grinder is accurate, tighten the torque to improve the abrasive manifestation method, the grinding and gear transmission, the clamping mechanism of the main cable, the adjustment should be adjusted, the adjustment should be adjusted. In the park, to ensure the safety of the equipment and ensure the safety of the operators and equipment. Product workpiece and other dirty things, pay attention to operation. If the abnormal behavior is defeated, the cardiac arrest, hotness, climbing, noise smell, fluctuation, should be stopped immediately, defect cleaning, and continuous operation.

The operation should be completed accurately and cleaning. In the general operating position of electrical equipment and pneumatic operation power switch, completely interrupt the equipment work, disconnect the switching power supply, pneumatic valve, and remove the visceral disk. The principle of complicated and variable cable valve has shifted, which clearly proposes to give oil and repair. Fill in the device manual shooting sound.