The winding machine is an industrial equipment that is used to wind the winding. It can also automatically complete the actual operation of the winding according to the setting process and main parameters. After designing a winding machine, the winding direction must be set. The direction of the winding is generally divided into two types: positive and reverse around. The row is that the wire is from left to right. When designing the winding direction, you should choose according to the characteristics of the wire and its winding. From these aspects, the winding method is designed in detail from these aspects.

1. Select the winding direction according to the characteristics of the wire

The characteristic of the wire is one of the key basis for setting the direction of the winding. For some wires, such as metal wires, alloy lines, etc., because the material is hard, it is easy to produce ground stress deformation during the winding session. Anti -winding can reduce the friction between the wire and the roller bearing, thereby reducing the pressure variation of the wire. For some soft wire materials, such as plastic wires and cables, because their materials are too soft, it is very easy to bend in the winding session, so it is appropriate to choose a positive winding method. It can increase the tolerance of the wire, thereby reducing the bending of the wire.

2. Select the winding direction according to the winding regulations

The rules of winding are one of the key basis for setting the direction of the winding. In some places that require high, such as aerospace engineering and automotive industry, the accuracy of the cable must be ensured, so the anti -winding method must be adopted. Anti -winding can reduce the pressure deformation of the wire, fully ensure the accuracy of the cable accuracy. However, in some places with relatively low regulations, such as electrical products, electronic products, etc., work efficiency must be improved, so a positive winding method can be used. It can increase the tolerance of the wires, thereby reducing the bending of the wire and improving the efficiency of work.

3. Adjust the abrasive and starting point in combination with the actual situation

When designing the direction of the winding, the abrasive and starting point must be adjusted in combination with the actual situation. The abrasive gear is the main component to promote the wound winding. It should be adjusted according to the diameter and winding standard of the wire. The starting point is that the wire is gradually wounding from a certain fixed point. Generally, the middle location of the rolling wheel bearing of the wiring roller will be built to ensure that the wire is not easy to swing left and right during the winding link. When designing the direction of the winding, the abrasives and starting points must be adjusted in combination with the actual situation to ensure the accuracy and safety of the winding direction.

4. Develop trial around

After the setting is completed, test is to check to check whether the winding machine can be used normally according to the set program. When testing, you need to carefully observe the tightly loose levels of the wire, the total width of the winding, and the termination of the perspective. At the same time, you also need to check whether the stability and precision of the equipment meet the regulations.

All in all, after designing the winding machine, various parameter settings should be performed according to the characteristics of the wires and winding standards, especially the winding direction settings. It is necessary to fully consider from many aspects such as wire characteristics, winding regulations, and specific situations, and choose the direction of the winding suitable for you. At the same time, you also need to conduct a trial to ensure that the device can be used normally according to the setting program.