Basic equipment for winding machines (consisting of mechanical parts and electrical control systems, but with the rapid development of technology, modern automatic winding machines have been debugged It will also be more difficult and refined than other electronic processing equipment. The Xiepu winding machine has developed and produced a winding machine for many years. It has rich experience in using debugging by winding equipment. Here, we will give you a brief introduction. I believe us As long as you have the basic concepts and methods, you can debug your own satisfactory coil after you practice. African crystal three -dimensional rolled iron heart -cooled three -dimensional high and low pressure integrated machine

The three main parameters of the winding machine, the diameter of the lacquer cable, and the wounding range are the three most important winding parameters of the winding machine. It is often used in the skeleton coil.

First, how should I set up the starting position? Where is the skeleton coil? In fact, there is no fixed position starting the starting point on the skeleton. As long as the measurement function of the device control system can be used, the specific starting position and value can be measured; the technicians can also use the manual measurement to measure the value, use the specific location as the reference, and click the ruler to actively measure. When setting this point Specific coils are wrapped in direction.

Second, the diameter of the lacquer cable is specific. The daily use of the lacquer line has different diameter. The specifications of different lacquer lines will produce the effect of different row lines. Pay attention to the specific values of the diameter of the line diameter when using different materials. Essence

Third, the width value of the winding width sets the winding width of the winding width, we can understand the value between the end point from the winding of the winding to the end point of the winding. Usually, the coil winding length can be known through the value. Of course, when setting, it is necessary to consider the slight deformation caused by the effectiveness of the use. Essence

Fourth, for the types of line materials of different coils, the specific circle of products, the number of folding layers are equally wound, and the degree of demand must be quite understood. The quality problems such as threads and steps and other problems must be strengthened to the torque power of the winding machine when using at low speed.

5. When the coil is a square type is a square type, the winding speed of the coil can not be too fast, otherwise the unevenness will occur, which will affect the number of folding layers and the number of circles. In addition, the distance between the coil and the rower should be arranged reasonably. It is easy to fall into other layers when it is low. It is easy to jump the line when it is high. Tension is unstable and affects accuracy.

6. The winding machine will reserve auxiliary functions such as lap presets, automatic parking, front and reverse winding, automatic cross -slot, etc. In the process of use, you must start the slow car and stop the winding machine in order to protect the winding machine. Slow car reduces the structure of the winding machine and the lacquer wire tension. Generally, it should be set up within three laps.

Of course, we just talked about the above-some very basic winding methods of winding machines still have many factors in actual production. This has to be slowly understanding ourselves.