The fully automatic winding machine can be the coils of the coil induction, including the surrounding coils and the fixed bald coils. Set on time, there will be some differences around the different coils. Set the main parameters properly, and adjust the tension and line -loading methods to surround better artworks and better coil products. Together, the fully automatic winding machine may encounter various problems during the operation. The more common phenomenon is shown below.

1. The coil lines are uneven. When showing this kind of situation, the need to analyze the problem should be presented in normal processing, or it is presented after the product replacement adjustment. Under the previous situation, most of the situation is caused by hardware failure, and in the following situation, it is generally designed. The hardware failure may be because the fixture is loose, the wiring mechanism is tightened screw loose, and the lack of the lack of the neutral natural environment of the wiring mechanism causes a common failure of the wiring in the load operation of the servo motor.

2. The position of the end of the motor rotor is not accurate, which is also a more common situation of active winding machines. This kind of situation is usually caused by the braking problem. For example, loose car brake pads may wear gray black car brake pads. In addition, there is a lot of contact with the settings of the brake pedal. If the time is not good, it will also cause the spindle positioning to be wrong. To solve these problems, you need to replace the brake pads or adjust the braking system.

3. The coil of the winding machine may be prohibited. Perhaps the total number of winding machines is deviated. Usually, the sensor may control the problem. As a result, the winding machine cannot work properly.

4. A full -automatic winding machine is announced when running. There is no abnormal problem to distinguish between sound differences. Naturally, this demand is more professional.

During the running link of the automatic winding machine, the body cannot be close to the flip component after running the winding machine. If the demand is adjusted, the demand is the first to terminate the operation of the machine. Adjustment must ensure your safety. restart. In addition, operators should not wear gloves, wear sleeves and long hair. If the winding machine announces the abnormal sound, the demand is temporarily stopped and the actual operation is temporarily, and the professional and technical personnel are found to repair it.